- See below for temperature on different garments
- See below for time on different garments
- Warm
- Medium, even pressure
- Cut in reverse
- Cotton, polyester, blends, nylon, uncoated nylon, acrylics,spandex, lycra, vinyl, and genuine leather.
- Wash warm/cold. Suitable for tumble dry and dry cleaning but not if applied to Nylon garments.
Additional Instructions
Application instructions for dazzle cloth, shiny polyester materials, and coated polyester materials:
Damp a cloth with rubbing alcohol (isopropyl alcohol), then gently apply it to the area on the garment you want to apply your design. Allow it to dry and apply your material. This will allow the adhesive to better penetrate the garment.
We highly recommend that you wash and dry your garments prior to pressing your design. This will also allow the adhesive to better penetrate the garment.
Cotton
[medium pressure]
265°F - 5 sec.
300°F - 4 sec.
320°F - 3 sec.
Cotton/Polyester
[medium pressure]
265°F - 5 sec.
300°F - 4 sec.
320°F - 3 sec.
Polyester/Acrylic
[low pressure]
300°F - 5 sec.
Impregnated Textiles (Nylon, etc.)
[low pressure]
300°F
• Pre Heat 5 sec.
• Apply to Nylon 5 sec.
• Remove PET liner, cover transfer with silicon paper & apply for further 10 sec.
Damp a cloth with rubbing alcohol (isopropyl alcohol), then gently apply it to the area on the garment you want to apply your design. Allow it to dry and apply your material. This will allow the adhesive to better penetrate the garment.
Application instructions for dazzle cloth & shiny polyester materials:
We highly recommend that you wash and dry your garments prior to pressing your design. This will allow the adhesive to better penetrate the garment.
Cut Settings for Graphtec CE6000:
Settings can alter for each cutter and how dull or sharp the blade is. Test Cutting is Recommended.
1. Offset: 0
2. Speed: 25 cm/s
3. Acceleration: 4
4. Cut Force: 17
*Heat Transfer Warehouse uses a 45 Degree Blade
Cut Settings for Silhouette Cameo:
Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.
Material: Heat Transfer, Smooth
Blade: 3
Speed: 8
Force: 6
Cut Settings for Cricut®:
Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.
Set Material: Iron-On
Pressure: Default
Blade: Fine-Point Blade (Standard)
