- 311° F
- Cover with heat transfer cover sheet preheat garment for 2-3 seconds; Tack design for 10 seconds (face side) ; Turn inside out heat for 20 seconds on adhesive side
- Peel Cold
- Medium pressure
- Cut in reverse
- Adheres to 100% cotton, poly/cotton blends, 100% uncoated polyester, Lycra/spandex
- Wait 24 hr before first wash. Machine wash cold w/mild detergent. Do not dry clean.. Do not Bleach. Dry at low setting
-
Need help with your artwork? Check out our Artwork and Mockup Resources.
Additional Instructions
Application instructions for dazzle cloth, shiny polyester materials, and coated polyester materials:
Damp a cloth with rubbing alcohol (isopropyl alcohol), then gently apply it to the area on the garment you want to apply your design. Allow it to dry and apply your material. This will allow the adhesive to better penetrate the garment.
We highly recommend that you wash and dry your garments prior to pressing your design. This will also allow the adhesive to better penetrate the garment.
1. Cut In Reverse
2. Weed
3. Preheat Garment 20 seconds
4. Tack design for 10 seconds - face side
5. Turn inside out heat for 20 seconds on adhesive side
Cut Settings for Graphtec CE6000:
Settings can alter for each cutter and how dull or sharp the blade is. test cutting is recommended.
1. Offset: 0
2. Speed: 25 cm/s
3. Acceleration: 4
4. Cut Force: 30
*Heat Transfer Warehouse uses a 45 Degree Blade
Cut Settings for Silhouette Cameo:
Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.
Material: Heat Transfer, Flocked
Blade: Standard, 10
Speed: 4
Force: 33
Cut Settings for Cricut®:
Settings can alter on how dull or sharp the blade is. Test Cutting is Recommended.
Set Material: Light Cardstock
Pressure: More
Blade: Fine-Point Blade (Standard)
