Orange Water Marble HTV for Shirts and Garments
11" printed workable space Mask & Squeege is no longer included in your order, click here to purchase your mask If ordering this product it may delay your standard shipping times depending on order value and time order was placed Please see our shipping policies May delay your order 1-3 business days; depending on the time the order is placed and the quantity. This is a Fargo only item, your entire order will ship from Fargo. Transit times may vary. Colors are subject to change without notice Accessories Fashion Sign Vinyl Prints
All your favorite patterns on our low temp heat transfer vinyl! Easy to
cut weed and applies to multiple garment types.
Product Details
- 11" printed workable space
-
.4-.5" white space on either side of the pattern, please see image for
clarification. This does not effect your print. Each pattern is printed 11" x 36"
or 11" x 180"
- Self Adhesive Liner
- 100 Microns
- Matte finish
- Composition: PU
-
This product requires a heat transfer mask: KTM Mask
- Colors are subject to change without notice.
Production Timeline
- All patterns are printed on demand.
-
May delay your order 1-3 business days; depending on the time the order
is placed and the quantity.
-
This is a Fargo only item, your entire order will ship from Fargo.
Transit times may vary. Please see our shipping policies for further
details.
How to use our printed patterns
- Load the the vinyl pattern side UP in your cutter
- Cut your design right reading, do NOT mirror
- Weed away excess
-
Apply your heat transfer mask of choice
-
Please note a heat transfer mask is required for this material to
work properly
- Squeegee your mask onto your design, smooth it out
-
Flip your design over so the pattern is not on the table and the liner
is facing up
- Remove the liner from the material.
- Cotton, Polyester, and 50/50: 266°F | Nylon: 302°F
-
Cotton, Polyester, and 50/50: 5 seconds Nylon: Preheat for 5 seconds
and press for 5 seconds. remove liner and cover with a teflon sheet
and press for another 10 seconds
- Peel warm
- Medium, even pressure
- Cut right reading
- Cotton, Polyester, Uncoated Nylon, 50/50 blends
- Wash inside out. Tumble dry.
Additional Instructions
Cut your design right reading
Weed away excess material
Mask
your design with a recommended mask
Remove the liner of the mask
Press
your design at one of the temps and times listed above
Peel warm
CUT SETTINGS
Cut Settings for Graphtec CE6000:
Settings
can alter for each cutter and how dull or sharp the blade is. Test
Cutting is Recommended.
1. Offset: 0
2. Speed: 25 cm/s
3.
Acceleration: 4
4. Cut Force: 16
*Heat Transfer Warehouse uses
a 45 Degree Blade
Cut Settings for Silhouette Cameo:
Settings can
alter on how dull or sharp the blade is. Test Cutting is Recommended.
1.
Smooth Heat Transfer Material Setting
2. Blade at a 1
3. Speed
at 5, Pressure at 6
4. Double Cut/Cut on Mat
