• 330° F-335° F
• 3 seconds
• Peel warm, cover with teflon sheet, repress for 10 seconds
• Firm, even pressure
• Remove heat liner. Cut material in reverse
• Cotton, uncoated polyester, fabric blends, spandex, lycra, wool, linen
• Wash inside out, cold water, gentle cycle, tumble dry low heat

Additional Instructions

To sublimate: Heat sublimation paper on top of already pressed vinyl at 390° F for 30 seconds.

*Paper heat settings may differ No Nylon.

We do not recommend this as a bottom layer material.  

Application instructions

for dazzle cloth, shiny polyester materials, and coated polyester materials: Damp a cloth with rubbing alcohol (isopropyl alcohol), then gently apply it to the area on the garment you want to apply your design. Allow it to dry and apply your material. This will allow the adhesive to better penetrate the garment.

We highly recommend that you wash and dry your garments prior to pressing your design. This will also allow the adhesive to better penetrate the garment.

Cut Settings for Graphtec CE6000:

Settings can alter for each cutter and how dull or sharp the blade is. test cutting is recommended.

1. Offset: 0

2. Speed: 25 cm/s

3. Acceleration: 4

4. Cut Force: 23

*HTW uses a 45 Degree Blade

Cut Settings for Silhouette Cameo:

Settings can alter on how dull or sharp the blade is. Test cutting is recommended.

1. Flocked Heat Transfer Setting

2. Blade at a 3

3. Speed at 5, Pressure at 33

• GlitterFlex 2 PDF Instructions