WALAKut Metallic Puff Heat Transfer Vinyl 10"
Important Application Notes:
WALAKut Puff Metallic differs from our standard WALAKut Puff line and REQUIRES a 2-press
application process. After the first press, the carrier must be peeled warm and the design
should be covered with a cover sheet, then pressed a second time to activate the puff effect.
- Actual width 9.75"
- Metallic Finish
- Not suitable for layering
- 300-500 Microns thick
- Sticky liner
- CUT SHINY SIDE UP
- CPSIA certified for use on children's clothing
- Laser compatible - this product contains no PVC and will not emit hazardous fumes
- Not recommended to apply this material with a home iron
- WALAKut HTV
- WALAKut Puff
- Accessories
- Heat Presses
10" (9.75") Pricing:
9x12 sheet = $4.00
1 yd roll = $10.00
5 yd roll = $40.00
10 yd roll = $75.00
27 yd roll = $180.00
- 302-311° F
- Two presses - 1 press for 3 seconds, remove carrier, let cool down. Once cooled, press again for 8 seconds.
* Allow metallics to cool before repressing
- Peel Hot
- Firm, even pressure
- Cut in reverse
- Cotton, Uncoated Polyester, Fabric Blends, Polyester/Acrylic, and Similar Fabrics - NO NYLON
- Wash inside-out, cold water, gentle cycle. Tumble dry low.
